If public does not work you should login to the device and check what it is using for the SNMP community. This includes all graphs, and html files. This directory is ideally where your web server is running, so you would be able to view these files over the network. Using cfgmaker, it will create a seperate page for each target interface.
You can use indexmaker to view all targets on the one page:. This will generate the file mainindex. Inside the mainindex.
This will generate files located in the WorkDir you specified earlier. This creates an initial MRTG config file for you. Note that in this file all interfaces of your router will be stored by number.
Unfortunately, these numbers are likely to change whenever you reconfigure your router. In order to work around this you can get cfgmaker to produce a configuration which is based on Ip numbers, or even Interface Descriptions. Check cfgmaker. If you get an error message complaining about no such name or no response , your community name is probably wrong.
This is the interface speed Default is 10 megabits; for Mbit devices use and so on…. It is normal to get errors for the first two times you run this command. The errors will alert you about the fact that there have not been any log files in existence before.
If you take a look at those web pages they are not very exciting yet. You need to have the MRTG files run every five minutes to produce the desired results. Just run it again after a few minutes. You should now be able to see the first lines in your graphs.
This will actually updates the graph in every 5 mins. Data yang ditampilkan di aplikasi MRTG berupa data riil time dan di update setiap 5 menit sekali. Anda bisa masuk ke dalam salah satu grafik untuk melihat detail hasil monitoring seperti di bawah ini:. No comments:.
Subscribe to: Post Comments Atom. Total Pageviews Last 7 Days.
0コメント